Posted on September 23, 2017 in News
Exhaust air purification systems are suitable for kitchens, laboratories, snack businesses, butchers or even manufacturing companies with new technologies for the gastronomy of exhaust air cleaning system. Constantly annoying odours or fumes are created in each operation. Smells when frying, cooking and roasting, but also already exist deposits of fat on the inside of the exhaust systems are produced in the hospitality industry. When cooked in the kitchen, or deep-fried, heavily grease-contaminated vapors rise and flow through the exhaust air systems, where they are then set. What represents a major fire hazard, as ventilation ducts and ventilators can clog. Also, also molds can cause because moisture can no longer be deducted through the clogged pipes.
Therefore, exhaust air purification systems are a good solution. They use integrated active carbon filter, bags and pre-filter, filter the air and leave it clean again. Activated carbon is perfectly suited to the absorption of bad odours. Also flame protection filter in the fixed fats to prevent it could ignite. In the catering industry, there are new exciting technologies.
Environmental protection plays an important role. Therefore upgraded now also in the field of exhaust systems. Today there is no longer only the traditional systems, but also exhaust air purification systems with for example ozone technology. This technology is designed for high and demanding requirements in the hospitality industry. It is suitable for all kitchens and almost maintenance-free. The technique is very environmentally friendly and effective immediately. The systems are easy to retrofit in existing kitchens or mount. No specific prior knowledge is also required, neither of the restaurateurs or kitchen staff. It can be continued normally, as before. The technology brings many benefits. For example an odor reduction by 95%, if you use a downstream catalyst 99.9%. Also prevent deposits on the inside of the hood, which also reduces the risk of fire. Maintenance and maintenance costs can be kept with these plants and you are also following components associated only with low cost. Also, you can use these systems to the heat recovery. Each restaurateur should however regularly wait filters and systems and maintain to ensure a continuous protection. But where do you even get exhaust systems? You can order it now actually in the Internet. A well-known online shop is for example the Gastroplus24. The company is active in the catering industry have long and you will find everything about our catering supplies in their range. Specialized have been on ventilation systems to self build. Therefore you will find both exhaust air purification systems with activated carbon, with or without prefilter, and also exhaust air purification systems with ozone. Today is it for any restaurateur slightly to get the right exhaust system and order them quickly and conveniently online!
Posted on September 16, 2017 in News
While there is a challenge more traditional than classic vegetable cultivation and agriculture there is no science as modern and avant-garde as genomics. And an Israeli, Evogene, company is at the forefront in integrating old and new technologies with a specific goal: improve and increase the provision of food, food and Therapeutics that will heal the planet safely and efficiently. Genetically modified foods, or organisms (GMO), are plants that have been genetically altered with genome of other species, such as bacteria, or animal. Today, these new super plants can grow with resistance to disease, insects and drought, or have specific qualities as a sweeter taste, or a higher starch content. Currently in the world, five genetically modified fields are being widely cultivated cotton, barley, soybean, corn, and cinnamon.
GM crops were introduced for the first time in the market about 10 years ago, and even though the industry is emerging, growing rapidly, with a market valued at about $ 4 billion a year. However, there is great hostility toward GM foods. In Europe, the public antipathy towards crops is particularly strong, and there is an absolute ban on GMO products. This prohibition has had an impact in many other countries around the world, including Israel, that does not matter nor cultivated GM crop. What Evogene a subsidiary company of Compugen life sciences offers is a less threatening version of GM crops.
Instead of introducing genes of other kingdoms such as bacteria or animals, technology acceleration of the evolution of Evogene, the EvoXellerator, uses genes from the same plant, a process that the company called EMO (modified by Evogene organism). The platform mimics, directs, and accelerates the evolutionary processes in plants to avoid the limitations of genetic variation that occurs in every day of cultivation techniques. Evogene is one of the few companies of plant biotechnology in Israel and focuses on improving the features of vegetables, such as sweet flavor in the tomatoes or greater resistance of the plant to the salty soil. medtronic-plc-3m-co’>Essex Financial by clicking through.
Posted on September 15, 2017 in News
Trays (or pallets) was used for transportation of more than 100 years ago. Starting in the forties of last century, pallets gradually became popular during the transportation of various cargoes. Today even the most conservative industries use this method of transporting materials, removing from it the logistical and economic benefits. The rate of use of packaging grew steadily from the beginning industrial revolution. Pallets slowly entered the life in the early decades of the 20 century. At the time, were the dominant transport rail, in which required rigid packaging goods.
The trend towards Use of corrugated cardboard has become a landmark for the development of palletizing, as boxes on pallets can be grouped and protected. The predecessor of the wooden pallets wood was runner (skid). He first appeared on the American factories and used with first loaders. Runners were two standing on the side boards, planks fastened on top. Designed by snakes, always followed by changes in opportunities for trucks: the above the wheel started to lift goods to load, the greater the weight of the load became, the greater the burden was on the design of the runners. In 1925, after the addition of the lower boards to the pallet runners turned out.
The breadth of pallet very closely linked with the development of the lifting and transport equipment, especially forklifts. Development of pallets to continue and further the need to lift the loader and front and back, then – with the need to store the pallets on each other with the possibility of easy access to truck. Technology development palletizing could get rapid development in the 1920-1930-ies, but this did not happen, because of the Great Depression at which any such phenomena as unemployment, lack of capital and other negative factors. Great impetus to the use of pallets has occurred during the Second World War, because with the U.S. entry into World War ii there is need for urgent reform of the transport group of goods. Palletizing received enormous development precisely because of the need of U.S. industry in an organized ship a huge amount military and humanitarian supplies throughout the world. Because number of male workers during the war was limited, palletizing allows you to load more material fewer people. Also increased performance and storage capacity, reducing the need to construct additional facilities. Pallets have proliferated during the war in Europe, although increasingly they are used in Pacific. Now pallets are made of different materials: wood, chipboard, plastic, metal. First by the manufacturer of pallets was founded by Walter Krukov company nwpca (National Wooden Pallet and Container Association), the scale sizes of pallets which is the first standard scale. Currently, U.S. standards are established document uniform standart for wood pallets, approved nwpca (National Wooden Pallet & Container Association). Pallet size by American standards: 4 ftx 6 ft or 6 ftx 6 ft. In Europe, mostly taken pallets (with stigma EUR) with 1200×800 mm. and finpoddony (c mark FIN) with the dimensions 1200×1000 mm. Organization of epal (European Pallet Association) brings together the leading manufacturers and monitors the quality pallets, which are covered documents ISO3676, iso TK/22, ispm 15, uic norms 435-2 / 435-4.
Posted on September 12, 2017 in News
First, even the best inks are not perfect, so the combination of cyan, magenta and yellow inks instead of a black almost always give a dirty-brown color, and secondly, the application too much paint on a certain stretch of paper leads to a glut of it, causing a noticeable reduction in print quality. To reproduce fine detail and deep shadows printers in addition to blue, magenta and yellow process inks using a fourth ink – black (CMYK). Separations to reproduce halftone color image through the printing machine, it (more precisely, it contains a page) must be subjected to color separation, and then display a single photo forms for each triad colors (cyan, magenta, yellow and black), and for each spot color used in the color design of this page. In Printing from the resulting photoforms made printing plates, which are installed in the press. (Printed forms for spot color is often called dies.) Technology UCR and GCR introduction of black paint in the color process Reproduction solved the problem of creating a black color that it was impossible to get a simple combination of 100 percent process inks CMY.
However, in some situations, this method causes other problems, such as excess paint on certain parts of the paper. In such cases, the printers use technology UCR (under color removal – subtract color from the color black) and GCR (gray component replacement – replacing the gray component) that allow minimize the total amount of applied paint on paper. UCR technology is primarily used to give depth to the shades of neutral colors and images.
Posted on September 11, 2017 in News
Two-thirds of those patents are Monsanto and Basf together with junior partners. (ETC Group, may 2008) The fact, that faced with this reality lately gives us wharton.universia.net, us that: Brazil has shifted in the second put by surface to Argentina, specialized in crops are soybean, corn and cotton, has 21.3 million hectares. Respite of Brazil is due to his remarkable increase (35%) in the last year, in a clear example of the commitment that the Government of Lula da Siva has made this production model. Other markets where genetically modified crops are allowed, such as India and Canada have a production of 8.2 and 8.4 million hectares respectively are placed away from them. Genetically modified products are implanted for more than one decade (1996 was the first year of their marketing). People from more than 50 countries consume products containing ingredients extracted products genetically modified.
Your process comes from a basic premise: ensure that crops are more efficient from the change in the genetic material. The technique is based on identifying a specific gene in a living organism, isolate it and multiply it, to then integrate it into one of the chromosomes of the receiver. The origin of this type of products is located in United States. It was in 1993 when the first modified in the North American country plant was obtained. Eleven years later, America allowed the marketing of the first transgenic food. It was a long-lasting tomato, created from a complex technique that allowed inhibit the enzyme responsible for the aging of the vegetable. Since then, it has increased the production and consumption of genetically modified food and it is estimated that, today, the world surface destined to the production of biotechnological crops amounted to 134 million hectares, an extension that is distributed, disparate form, among 25 countries. In recent years the crops biotechnology are growing faster in developing countries than in developed countries, according to Vicente.
Posted on September 11, 2017 in News
Today's designers try to take into account the selection of kids clothing and sew a children's clothing, which comply with all requests of small buyers. Style baby clothes picked up mom and dad, although a bit early babies themselves are beginning to signal the choice of vending tone. Quite often the choice color depends on the temperament of the child – a proactive child chooses cheerful and bright colors, a thoughtful child to give up his choice more pastel, muted tones. Children, like everyone, is entitled to their opinion and his statements. This, of course, applies to children's clothes. Be sure to pay attention to the interest of your child, even if they will not give up significant. Do not have to directly criticize the interests of the kids, they can be closed.
Children is desirable to know that they have a right to personal opinion. And should not all the time to watch every act baby. Today's kids – it's active and meaningful part of this circle. Kids lead an active lifestyle, watching the fresh technology and focus on fashion in the children's clothing. Fashion is considered one of the most significant factors of modernity and fashion in children's clothes does not stop at the level of specific styles, colors and fabrics. Buying children's clothes, some with no experience, parents often make many mistakes. Some children's clothes give the child his friends and acquaintances of parents and children are somehow more likely to choose noticeable, and not practical things.
Children's clothing depends on the mode, as well as adult clothing, but regardless of the factors of fashion and taste, There are certain requirements to it. First, children's clothes should not be close, that the child could safely move it. Free cut and natural, "breathable" fabrics, pleasant to the skin of the child, most suitable for this. Synthetics in the children's clothes should be shunned because it can cause irritation or allergy. Often, when buying children's clothes, leading to start trying to dress up a baby for more, forgetting the most important thing. This lust is worth understanding, and yet we should not forget about the essential issue – the comfort of the child. Again, another good one common mistake is that kids are not the best of wraps – toddler becomes very hot and feel trapped. Although when our descendants say: 'let him be a little cooler than too warm. " Children's Clothing
Posted on September 10, 2017 in News
One of the requirements photocomposition is harmony. This may be a harmony of horizontal and vertical lines that complement each other, the harmony of colors, harmony of light and shadow, the harmony of the model and the surrounding space, and so more Harmonious unity of the individual elements can not be without balance, without the addition of one another. For example, a track built on some contours to avoid monotony recommend to revive any vertical accent or to add complexity of diagonal lines. Balance can also be achieved as a result of the symmetrical construction of the photograph, in case the asymmetry can not override the right lower angle compared with the left, heavily overloaded top also gives the impression of compositional unbalance. Symmetrical and asymmetrical compositions can be created for any type of shooting, and will depend primarily on the photographer's intent, and then from his chosen point of view.
Posted on September 2, 2017 in News
The notion of security as a general scientific category is defined as a condition of the system, in which she the one hand, able to withstand the destabilizing effect of internal and external threats, but with the other – its existence and operation does not create threats for the elements of the system and the external environment. In this case, the natural measure of security systems are presented: – in terms of ability to resist destabilizing impact of external and internal threats – the degree (level) to maintain a system of its structure, technology and performance of exposed destabilizing factors – in terms of absence of threats to elements of the system and external environment – the degree (level) the possibility (or impossibility) of occurrence of such destabilizing factors, which may present a threat to the elements of the system itself or external environment. ; Purely mechanical interpretation of the above formulation leads to the following definition of information security. ; Definition 1.1. Information security – a condition considered system, under which it is on the one hand, able to withstand the destabilizing impact of external and internal information threats, and with another – its existence and operation of information does not create threats to elements of the system and the external environment. It should be noted that information as an indispensable component of any organized system, on the one hand, is vulnerable (that is very accessible to the destabilizing effects of large number of diverse threats), and the other may itself be a source of too big and too diverse number of threats for both elements of the system itself, and for the environment.